Thursday, 2 August 2012

Shortening a skirt or dress.

Here's a step by step guide to shortening a hem.  This should take approximately 30-45 minutes depending in experience - no experience necessary!



Firstly, you will need:

  • Iron-on hemming tape (you can find similar here)
  • Iron/ironing board
  • Pins (find similar here)
  • Clothing - dress/skirt/etc
  • Scissors 
  • Needle and thread (optional)


Step One 
  • Try on your dress, fold over the front (back on itself) and adjust to the new length.  Pin three pins at the front at the length you want.  Take off/put on your dress or skirt and add more pins until you have the correct length all round and at least 6 pins in place.  Use two mirrors if it helps to see the back properly.
  • Make sure the new hem line is poker straight.  
Step Two
  • Put the iron on to heat up (see this useful guide for the correct temperature) and set up your ironing board.
  • Turn your dress inside out and lay flat on the ironing board with the new hem in the centre of the  board.  Lay the rest of the material hanging between you and the ironing board.  
  • Take a length of hemming tape of approximately 30cm and place as straight as possible at the edge of your new hem between the fold of the material.  Make sure the hemming tape is at the edge and the line is straight.   Make sure there are no gaps between the hemming tape and no creases on either side of the material!  
Step Three
  • Iron along the hem slowly and firmly adding more hemming tape along the new hem line as necessary.  
  • To finish cut away any excess material and add small stitches if necessary to secure your new hem line.  
The hemming tape should give a crisp and straight finish first time round!

Et viola and good luck! 

Kate xx